Reducer GMA 180-D-200, 180W, 200N·m
We offer gearboxes of the GMA series. Among their main characteristics, it is worth noting overload protection: in case of exceeding the load by more than 1.5 times the nominal torque, the protection system is automatically activated. This causes the engine to stop completely for 5 minutes, after which the system restarts, preventing the engine from overheating.
The device does not require additional transformers, as it works from a 220 V network, which provides savings on installation and additional cables.
Characteristics of GMA 180-D-200, 180W, 200N·m
- Power: 180 W
- Moment of force: 200 N·m
- Current strength: 1.8 A
- Rotation: 3.5 rpm
- Permissible length: ≤100 m
GMA Photos
Reducer assembly:
Before installation, read the instructions carefully - this will help to avoid errors and ensure the correct operation of the device. After installation, the motor must be located above the limit switch in any operating position.
After installing the reducer, the cable should be connected to the control unit, turn on the power, set the limit switch to the desired position, and then tighten the fixing screws.
If there is a side power source and the system needs to be lowered urgently, it is necessary to hold the pipe, then loosen the connection and slowly lower the pipe.
Service:
Regularly check the fixing screws, if they are deformed, replace them.
The gearbox does not require replacement or addition of transmission oil during its entire service life.
This product is suitable for ventilation and curtains of film greenhouses. If used for other purposes, consult with staff.